Finally I have information and pictures of my new lever system on the Glimakra.
I am very pleased with the results. The system was built by a friend to fit my 52 inch Countermarche Glimakra. Width of the lever frame was 6 inches and length 50 inches. I followed the directions in Peter's book with a few modifications as I wanted a 4 end block weave at 5 EPI . This meant the levers were very narrow 3/8" by 6/8" by 5 1/8". The hole drilled in the end was a bit over 1/8" and the texsolv fits snugly through it. I used fuse wire to pull the second texsolv through the hole when assembling.
My loom has two sets of horizontal jacks (figure 97 page 115 in Peter Collingwood's Rug Weaving Techniques). However I didn't need to omit the central lever. I also have the side cords passing through the system. There seem enough space to allow the cords to hang.
Another concern I had was that my shafts would not be wide enough to hold the eyelets to guide the cord. This has not been a problem I staggered the eyes as you can see in my pictures.
If you wish more information please contact me

Levers1
Work Begins
Cords